is there an A4 printable mounting hole template?

Post Reply
g000444555
Posts: 25
Joined: Sat Feb 11, 2017 11:47 pm
languages_spoken: english
ODROIDs: 9 x ODROID-C2
Has thanked: 0
Been thanked: 0
Contact:

is there an A4 printable mounting hole template?

Post by g000444555 »

I was wandering whether there is a printable mounting hole template for ODROID-H2, similar to the Raspberry Pi Mounting Hole Template (A4)?

I need it for a DIY project in order to drill mounting holes on a surface. The closest that I have found was this image describing the board dimensions, however, I don't think it's "normalised" to reflect the exact holes location on a printed A4 paper: https://wiki.odroid.com/_media/odroid-h ... h2_top.png

User avatar
odroid
Site Admin
Posts: 35334
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English, Korean, Japanese
ODROIDs: ODROID
Has thanked: 1096 times
Been thanked: 831 times
Contact:

Re: is there an A4 printable mounting hole template?

Post by odroid »

There are DXF CAD drawings files for various H2 cases in the product pages.
For example, you can find H2 Type-2 case 2D drawings in this link.
https://www.hardkernel.com/shop/odroid-h2-case-type-2/

You can print the bottom side plate with 1:1 scale for your DIY project.

Zabrus
Posts: 1
Joined: Fri Sep 20, 2019 11:57 am
languages_spoken: english
ODROIDs: xu4;h2;n2-4g;odroid-go
Has thanked: 0
Been thanked: 0
Contact:

Re: is there an A4 printable mounting hole template?

Post by Zabrus »

@odroid as i see, mechanical drawings from page ( https://www.hardkernel.com/shop/odroid-h2-case-1/ ) dont finished and havent some parts.
Image ( scr: https://take.ms/I1hca )

Is there any full verion of printable H2 case TYPE-1 ?

teeedubb
Posts: 32
Joined: Sun Oct 13, 2019 6:48 pm
languages_spoken: english
Has thanked: 8 times
Been thanked: 9 times
Contact:

Re: is there an A4 printable mounting hole template?

Post by teeedubb »

Did you manage to make some templates? I am in a similar position to you.

I have cropped the png image to the outside edge dimensions of the board and set the print dimensions to match the figure in the drawing in GIMP. My printer is packed away so it wont be till later tonight that I get to test to see if it works.

Post Reply

Return to “General Topics”

Who is online

Users browsing this forum: No registered users and 0 guests