[SOLVED] sd-executor exit with status 1

Moderators: mdrjr, odroid

[SOLVED] sd-executor exit with status 1

Unread postby redrocket » Mon Sep 17, 2018 2:15 am

Hello.
I have a problem with my C2
Dig throught the forum but with no luck

A few days ago there was a power outage. After that the power came back and the C2 start working as normally - solid red with blinking blue.
Yesterday i try to ssh to it but all the time the connection timed out. I looked at the C2 and the red was solid and the blue was blinking.

After i connected it to a monoitor the following error came up and the who;le system froze
Code: Select all
systemd[189]: Failed to open serialization file: Read-only file system
systemd[1]: (sd-executor) failed with exit status 1
systemd[1]: Failed to fully start up daemon: Protocol error
[!!!!!!] Failed to start up manager, freezing.
systemd[1]: Freezing execution


After that everything stops, but the C2 shows solid red with blinking blue

So any advice is welcomed
Last edited by redrocket on Tue Sep 18, 2018 3:30 am, edited 1 time in total.
redrocket
 
Posts: 23
Joined: Thu May 26, 2016 1:55 pm
Location: Sofia / Bulgaria
languages_spoken: english
ODROIDs: C2

Re: sd-executor exit with status 1

Unread postby moon.linux » Mon Sep 17, 2018 7:29 pm

Your filesystem is in RO mode, could you try following command to do filesystem check on reboot.
Code: Select all
sudo mount / -o remount,rw
sudo touch /forcefsck
sudo reboot

This will recheck the filesystem and fix some error.
moon.linux
 
Posts: 1159
Joined: Thu Oct 02, 2014 11:42 pm
languages_spoken: english

Re: sd-executor exit with status 1

Unread postby redrocket » Tue Sep 18, 2018 12:53 am

Hmmm that's the thing i cannot get to the login screen nor i have any access to command to write the commands.
Is there a way to edit the boot section on the sd card in order to run those commands?
redrocket
 
Posts: 23
Joined: Thu May 26, 2016 1:55 pm
Location: Sofia / Bulgaria
languages_spoken: english
ODROIDs: C2

Re: sd-executor exit with status 1

Unread postby moon.linux » Tue Sep 18, 2018 1:08 am

You need to check the filesystem of sdcard or emmc on other linux machine using following command.
Code: Select all
sudo fsck -fvy /dev/sdb2
moon.linux
 
Posts: 1159
Joined: Thu Oct 02, 2014 11:42 pm
languages_spoken: english

Re: sd-executor exit with status 1

Unread postby redrocket » Tue Sep 18, 2018 2:55 am

Hello.
Thank you moon.linux for your directions
I have a success in fixing the card but maybe in a different way
When I open the boot.ini on one of the lines i had this
Code: Select all
setenv bootargs ".... ro ...."


So i changed the ro to rw and from then it went up and fixed everything

However I'm not sure this is the way (although it's fixed)

So if this is the way to fixed it thank you
redrocket
 
Posts: 23
Joined: Thu May 26, 2016 1:55 pm
Location: Sofia / Bulgaria
languages_spoken: english
ODROIDs: C2


Return to Issues

Who is online

Users browsing this forum: No registered users and 2 guests