The included stl has countersunk thru connections for securing the case face, case back and stand brackets with M3 16mm screws. A few variables can be used to disable the top vent, brackets and the spherical indent for the SD-card. The SD-card indent is necessary to expose enough of the SD-card for insertion and removal, but the bottom half doesn’t print cleanly without support so it can also be disabled. The insertion of the SD-card poses no problems but even with the indent, the SD-card is still a challenge to grab for removal. Long finger nails, the use of tweezers or hemostats may be necessary.
Code: Select all
vent = true; // vent (true or false) bracket = true; // brackets (true or false) sd_indent = true; // sdcard sphere indent
4 M3 x 16mm cap or pan head screws
4 M3 nuts
4 M3 x 25-30mm cap or pan head screws
8 M3 x 6mm cap or pan head screws
I’m currently trying to locate a 120mm-200mm FPC cable to complete my build out. The wiki indicates that a 31pin 1x4 Lane cable is needed but does not specify the pitch(EDIT: .3mm pitch). Since there is room, it looks like a standard FPC cable with a twist can be used.
May 5, 2022 vuScape8m version 1.0
May 9, 2022 vuScape8m version 1.0.1
Stand brackets and holes adjusted, audio plug opening repositioned vuScape8m.scad