I try to install Homassistant on a Odroid N2.
For this i use USB3.0 eMMC Module Writer and flashe the image using etcher...
When i boot the n2 there is no blue light and the serical consol gives the following error:
U-Boot 2020.01 (Jul 03 2020 - 10:20:01 +0000) odroid-n2
Code: Select all
DRAM: 3.8 GiB MMC: sd@ffe05000: 0, mmc@ffe07000: 1 In: serial@3000 Out: serial@3000 Err: serial@3000 Net: eth0: ethernet@ff3f0000 Card did not respond to voltage select! unable to select a mode switch to partitions #0, OK mmc1(part 0) is current device ** No partition table - mmc 1 ** MMC Device 2 not found no mmc device at slot 2 starting USB... Bus usb@ff500000: Register 3000140 NbrPorts 3 Starting the controller USB XHCI 1.10 scanning bus usb@ff500000 for devices... 1 USB Device(s) found usb - USB sub-system
My question is: How can i do a recovery of the hidden boot blocks of the emmc?
What i tried so far:
https://wiki.odroid.com/accessory/emmc/recovery_xu4 -> I think this guide is just for XU3/XU4 Booards and not for n2.
https://github.com/home-assistant/opera ... issues/675 -> There are also other people having the same issue, but solultion doesn't work for me
Thank you very much for your help...