GPIO output change state to 0 alone

Post Reply
Fea
Posts: 1
Joined: Sun Jun 09, 2019 6:31 pm
languages_spoken: english
ODROIDs: XU4
Has thanked: 0
Been thanked: 0
Contact:

GPIO output change state to 0 alone

Unread post by Fea » Sun Jun 09, 2019 7:17 pm

Hi,

I have an Odroid XU4 on which I pass a transistor to different GPIO to control relays. I placed a 330 Ohm resistor between my GPIO and the base of my transistor.

however, when I activate or leave one of them, the one who is active, is put on hold. Could it be possible that the current is insufficient?

How can I overcome this problem? can be by adding a resistance between the base and the ground?

User avatar
odroid
Site Admin
Posts: 31377
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English
ODROIDs: ODROID
Has thanked: 52 times
Been thanked: 184 times
Contact:

Re: GPIO output change state to 0 alone

Unread post by odroid » Mon Jun 10, 2019 9:47 am

XU4 GPIO can draw/sink up to 5mA which must be enough to control generic MOS transistors.

Which transistor did you use?
Is it working with 1.8Volt GPIO?
Which relay do you use?

Post Reply

Return to “Hardware and peripherals”

Who is online

Users browsing this forum: No registered users and 0 guests