SATA port not working on HC1

Locked
alvaroednilson
Posts: 2
Joined: Sun Nov 26, 2017 4:04 am
languages_spoken: english, portuguese
ODROIDs: C1/HC1
Has thanked: 0
Been thanked: 0
Contact:

SATA port not working on HC1

Post by alvaroednilson »

I have an ODROID C1 for over two years and decided to buy an ODROID HC1 recently.

I also purchased a Western Digital Blue HDD for use with it, but connecting the HDD just does not work (the green led does not blink).

The HDD works normally with a USB case, I also tried with a Seagate Spinpoint and SSD Samsung EVO 950 and the result was the same, the operating system (I tried with Ubuntu minimal and OMV) does not recognize any disk.

Is there any special configuration or did I received a defective HC1?

phaseshifter
Posts: 3569
Joined: Fri May 08, 2015 9:12 am
languages_spoken: english
ODROIDs: U-2,U3+,,XU-3,,XU3-LITE,,XU-4
C1+,,C-2,,,n2+2G and n2 4G
cloudshell I and shell II
N-1,,N-2,...other odroid acc`s as well..vu7 etc..
Has thanked: 52 times
Been thanked: 49 times
Contact:

Re: SATA port not working on HC1

Post by phaseshifter »

you can use a xu3/4 minimum image or just an xu3/4 full ubuntu image

either should work....

pls post the output of these syntax..if the board has booted..if it does not boot then yes you have a problem..
if the blue light is not flashing after a few min`s then you have to check if you flashed the correct image..
use a 4.9 image 20171025..you can find it under the wiki xu4 section of op-sys`s

Code: Select all

lsusb

Code: Select all

lsust -t 
Build It And They Will Come...Be Bold And Mighty Forces Will Come To Your Aid..!!!

phaseshifter
Posts: 3569
Joined: Fri May 08, 2015 9:12 am
languages_spoken: english
ODROIDs: U-2,U3+,,XU-3,,XU3-LITE,,XU-4
C1+,,C-2,,,n2+2G and n2 4G
cloudshell I and shell II
N-1,,N-2,...other odroid acc`s as well..vu7 etc..
Has thanked: 52 times
Been thanked: 49 times
Contact:

Re: SATA port not working on HC1

Post by phaseshifter »

if your using a kingston sd card change it for a sandisk they are the most reliable i find...

for got to mention trying a different card..sozz..
Build It And They Will Come...Be Bold And Mighty Forces Will Come To Your Aid..!!!

alvaroednilson
Posts: 2
Joined: Sun Nov 26, 2017 4:04 am
languages_spoken: english, portuguese
ODROIDs: C1/HC1
Has thanked: 0
Been thanked: 0
Contact:

Re: SATA port not working on HC1

Post by alvaroednilson »

root@odroid:~# lsusb
Bus 006 Device 002: ID 0bda:8153 Realtek Semiconductor Corp.
Bus 006 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 005 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 004 Device 001: ID 1d6b:0003 Linux Foundation 3.0 root hub
Bus 003 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
Bus 002 Device 001: ID 1d6b:0001 Linux Foundation 1.1 root hub
Bus 001 Device 001: ID 1d6b:0002 Linux Foundation 2.0 root hub
root@odroid:~# lsusb -t
/: Bus 06.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 5000M
|__ Port 1: Dev 2, If 0, Class=Vendor Specific Class, Driver=r8152, 5000M
/: Bus 05.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 480M
/: Bus 04.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 5000M
/: Bus 03.Port 1: Dev 1, Class=root_hub, Driver=xhci-hcd/1p, 480M
/: Bus 02.Port 1: Dev 1, Class=root_hub, Driver=exynos-ohci/3p, 12M
/: Bus 01.Port 1: Dev 1, Class=root_hub, Driver=exynos-ehci/3p, 480M
root@odroid:~# fdisk -l
Disk /dev/ram0: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram1: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram2: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram3: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram4: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram5: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram6: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram7: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram8: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram9: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram10: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram11: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram12: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram13: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram14: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/ram15: 8 MiB, 8388608 bytes, 16384 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 4096 bytes
I/O size (minimum/optimal): 4096 bytes / 4096 bytes


Disk /dev/mmcblk1: 7.4 GiB, 7948206080 bytes, 15523840 sectors
Units: sectors of 1 * 512 = 512 bytes
Sector size (logical/physical): 512 bytes / 512 bytes
I/O size (minimum/optimal): 512 bytes / 512 bytes
Disklabel type: dos
Disk identifier: 0x3cedfd53

Device Boot Start End Sectors Size Id Type
/dev/mmcblk1p1 2048 264191 262144 128M c W95 FAT32 (LBA)
/dev/mmcblk1p2 264192 15522816 15258625 7.3G 83 Linux


The operating system starts without problems, the problem is the SATA port that does not work.

User avatar
odroid
Site Admin
Posts: 37222
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English, Korean
ODROIDs: ODROID
Has thanked: 1720 times
Been thanked: 1118 times
Contact:

Re: SATA port not working on HC1

Post by odroid »

I think the SATA bridge controller seems to be damaged.
Please contact "odroid at hardkernel dot com" with a link of this thread.
She will help your RMA process if you purchased the board from us directly.
Otherwise, contact your local distributor. Sorry for the inconvenience caused.

nicedreams
Posts: 19
Joined: Sun Jul 06, 2014 1:41 pm
languages_spoken: english
ODROIDs: ODROID-U3
Has thanked: 0
Been thanked: 1 time
Contact:

Re: SATA port not working on HC1

Post by nicedreams »

I started having the exact same issue with my Odroid HC-1. It doesn't detect Samsung solid state drive. I plug SSD into Linux desktop and can see it fine. I've tried another regular laptop SATA drive on the HC-1 and dmesg, lsusb, blkid, fdisk-l says nothing about a new drive for me to access. Other than that the thing works fine. Just can't use a hdd/ssd on it anymore. What can I do? It was only used as a file server at my house. There is a solid green light where the drive plugs in.

nicedreams
Posts: 19
Joined: Sun Jul 06, 2014 1:41 pm
languages_spoken: english
ODROIDs: ODROID-U3
Has thanked: 0
Been thanked: 1 time
Contact:

Re: SATA port not working on HC1

Post by nicedreams »

I went ahead and used another SDcard and put fresh Ubuntu on it. Now I can see the ssd just fine. Don't have a clue what went wrong since it hasn't been modified in months as it's just a file server. I read on the forums about some USB/SATA bridge update this month and maybe was messed up after update.

Rebuilding the rest of it, but wanted to let know working now.

User avatar
odroid
Site Admin
Posts: 37222
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English, Korean
ODROIDs: ODROID
Has thanked: 1720 times
Been thanked: 1118 times
Contact:

Re: SATA port not working on HC1

Post by odroid »

The USB-SATA bridge driver in HC1/HC2 should be very stable with Kernel 4.9.60+ or 4.14.5+
So you might need to check the kernel version.

Locked

Return to “Hardware and peripherals”

Who is online

Users browsing this forum: No registered users and 4 guests