[SOLVED] Is SSHD are compatible with HC1/UX4 ?

Moderators: mdrjr, odroid

[SOLVED] Is SSHD are compatible with HC1/UX4 ?

Unread postby lakano » Wed Sep 13, 2017 8:19 pm

Hi !

I would like to buy a SSHD (Hybrid-HDD), the Seagate FireCuda 2 To.
It's require 1.0A and 5V, and I have a PSU of 5V.
( model ST2000LX001 - http://www.seagate.com/www-content/prod ... 02299e.pdf )

Do you think it's compatible with HC1 ?

Thanks for your advices! :)

EDIT: My PSU is a 5V/4A delivered by AmeriDroid with the HC1.
Last edited by lakano on Tue Sep 19, 2017 9:33 pm, edited 4 times in total.
lakano
 
Posts: 11
Joined: Tue Sep 12, 2017 5:45 pm
languages_spoken: english
ODROIDs: HC1

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby phaseshifter » Wed Sep 13, 2017 10:20 pm

it should be ok although if you run into bother i would go for a 30 watt supply..i.e 6 amp supply..
the drive has an inrush current of 1 amp so the standard supply may not keep up

a hybrid drive has both ram and motor to drive ..
4.9.xx.xx odroids
phaseshifter
 
Posts: 2485
Joined: Fri May 08, 2015 9:12 am
languages_spoken: english
ODROIDs: opp sys.. ubuntu .kernel 4.9.xx.xx.c1+ ..c-2..xu3 lite,xu4...vu7,vu8,c-shell -II..c-shel-II,uart,hi-fi ,,hi-fi2,,show,w-board,6x16GB emmc`s 3.5 inch touch...other odroid acc`s as well

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby lakano » Wed Sep 13, 2017 11:17 pm

Thank @phasehifter for the reply :)
lakano
 
Posts: 11
Joined: Tue Sep 12, 2017 5:45 pm
languages_spoken: english
ODROIDs: HC1

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby lakano » Tue Sep 19, 2017 7:18 pm

Hi !
I've received my SSHD, and there is something wrong, this not boot entirely, I listen the noize of the sshd, and few seconds later it stop, and I can't ssh to the board ( I doesn't have the debug module to see what's happening exactly )

Currently I have the PSU sent by AmeriDroid ( 5V/4A EU ).
When I see the Watts measurements of the HC1 ( http://com.odroid.com/sigong/blog/blog_list.php?bid=189 ), there is only a peak at 15W/3A on booting.
My SSHD drive only require a 5V/1A, 1.7W writing, 1.6W reading, idle 0.5W.
So, if I understood, my current PSU *should* works with the HC1 + SSHD, no ?

I can buy a new PSU, but I would just be sure to buy it and if this doesn't works again...
Do I really need a 30W / 6A as you've suggested @phaseshifter ?

Thanks in advance for your advice.
lakano
 
Posts: 11
Joined: Tue Sep 12, 2017 5:45 pm
languages_spoken: english
ODROIDs: HC1

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby odroid » Tue Sep 19, 2017 7:24 pm

Did you buy 2TB SSHD?
We will try to get one here to test it even I think 5V/4A should be fine.

How is the blue LED? Can you access the SSH console?
User avatar
odroid
Site Admin
 
Posts: 25057
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English
ODROIDs: ODROID

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby Sentilix » Tue Sep 19, 2017 7:27 pm

I am using a 2 TB Seagate FireCuda ST2000LX001 with HC1, and it works like a charm.
Last edited by Sentilix on Tue Sep 19, 2017 7:29 pm, edited 1 time in total.
Sentilix
 
Posts: 11
Joined: Mon Jan 16, 2017 10:54 pm
languages_spoken: English
ODROIDs: C1+, C2, U3, XU4+CS2, HC1

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby odroid » Tue Sep 19, 2017 7:27 pm

@Sentilix
Which power supply do you use?
User avatar
odroid
Site Admin
 
Posts: 25057
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English
ODROIDs: ODROID

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby Sentilix » Tue Sep 19, 2017 7:29 pm

odroid wrote:@Sentilix
Which power supply do you use?


The official 5V/4A power supply.
Sentilix
 
Posts: 11
Joined: Mon Jan 16, 2017 10:54 pm
languages_spoken: English
ODROIDs: C1+, C2, U3, XU4+CS2, HC1

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby phaseshifter » Tue Sep 19, 2017 8:49 pm

is the blue light flashing..if so it has booted

what image did you flash to the sd-card...????

i see yes 360 mA on write cycle less on read..but 1 amp which is 5 watts ..spin up

also the drive may not have a valid partition table on it..not shure with hybrid drives ..
do a web search for "partition hybrid drive"..
it may be an issue..but no ssh over the network seems a different problem all together...
4.9.xx.xx odroids
phaseshifter
 
Posts: 2485
Joined: Fri May 08, 2015 9:12 am
languages_spoken: english
ODROIDs: opp sys.. ubuntu .kernel 4.9.xx.xx.c1+ ..c-2..xu3 lite,xu4...vu7,vu8,c-shell -II..c-shel-II,uart,hi-fi ,,hi-fi2,,show,w-board,6x16GB emmc`s 3.5 inch touch...other odroid acc`s as well

Re: Is SSHD are compatible with HC1/UX4 ?

Unread postby lakano » Tue Sep 19, 2017 9:32 pm

Problem fixed, this was my fault, the fstab was linked to the previous UUID of my old disk, so I suppose this was the reason.
I've booted on my old disk, removed the line in the fstab, and now I can see my SSHD (1,8 TiB) in fdisk ! :)
Thanks for your help & suggestions everybody :)
lakano
 
Posts: 11
Joined: Tue Sep 12, 2017 5:45 pm
languages_spoken: english
ODROIDs: HC1

Re: [SOLVED] Is SSHD are compatible with HC1/UX4 ?

Unread postby mad_ady » Tue Sep 19, 2017 11:55 pm

You can use autofs to mount the partitions on first access instead of stab which might lead to an unbootable system
User avatar
mad_ady
 
Posts: 2782
Joined: Wed Jul 15, 2015 5:00 pm
Location: Bucharest, Romania
languages_spoken: english
ODROIDs: XU4, C1+, C2

Re: [SOLVED] Is SSHD are compatible with HC1/UX4 ?

Unread postby odroid » Wed Sep 20, 2017 7:19 am

Good to hear the SSHD works with HC1 :D
User avatar
odroid
Site Admin
 
Posts: 25057
Joined: Fri Feb 22, 2013 11:14 pm
languages_spoken: English
ODROIDs: ODROID


Return to Hardware and peripherals

Who is online

Users browsing this forum: No registered users and 2 guests