Board Dimensions/Header Info

[taylorjtt]

I am designing a PCB that my ODROID U3 will plug into. I am looking for information on what type of header the expansion port is (part #) and a dimensioned drawing of the ODROID so that I can line up the mounting holes appropriately.

[odroid]

You can refer this link for the dimension of U3-Shield board.
http://www.hardkernel.com/main/products/prdt_info.php?g_code=G138760240354&tab_idx=2
The header of 8-pin expansion ports is 2mm-pitch.

[Panzerknacker]

I want to build for me a steel case like this one for the BBB http://www.logicsupply.com/components/beaglebone/boards-cases-kits/bb100/.
U3 + some small pcbs + 2 RS232 + 1W (3,5mm jack).
Where can I get the dimensions/drawings of U3 that contain the exact location of all plugs?

[odroid]

We will try to make & release a dwg file of U3 PCB with connectors in the next week.

[odroid]

Try this DWG file of U3 PCB.

U3_MAIN_Rev0.2.zip

(634.27 KiB) Downloaded 302 times

[dmarion]

Can we get the same for rev0.5 board?
I would like to get exact position of the SPI connector...

[ruppi]

Attached DWG file for U3 REV 0.5 PCB.

[sbkenn58]

This may be slightly off thread, but better, I think, than a new thread.
For me, it is a pity that the C1 doesn't have the headers on the back of the board, and be Pi compatible (camera in particular). Looking just at the weather module, it prohibits a case with the screen as the hightest component on the front. A weather module with extra inputs for remote temperature, humidity, and wind speed/direction would be great. I2C won't work at suffucuent distance to move the sensor board outside.