Custom USB 3.0 Cable with oCam-5MP?

Posts: 8
Joined: Mon Jun 08, 2015 8:23 am
languages_spoken: english
ODROIDs: ODROID-C1, USB Audio Adapter, RTC Backup Battery, USB-UART Module Kit, C1 3.2inch TFT+Touchscreen Shield, Weather Board
Has thanked: 0
Been thanked: 0

Custom USB 3.0 Cable with oCam-5MP?

Unread post by dlmutiny » Fri Oct 05, 2018 1:32 pm

I'm using an oCam-5MP with a C2. For my project, I'm trying to slim everything down as much as I can. Is it possible to make my own USB 3.0 Standard-A to Micro-B cable?

Is it as simple as matching the Pinouts between the two connectors? e.g. [ (Micro-B) pin 6 USB3 SSTX- to (Standard-A) pin 5 StdA_SSRX- ] so on through the rest of the pins.

USB 3.0 Micro-B pinout: ... nout.shtml
USB 3.0 Standard-A Pinout: ... nout.shtml

If that's the case, I'm not entirely clear on what to do with the OTG ID pin on the Micro-B connector.

Also, the Standard-A GND_DRAIN. I'm guessing that pin is wired to pin 8 GND on the Micro-B?

Post Reply

Return to “oCAM USB 3.0 Camera”

Who is online

Users browsing this forum: No registered users and 1 guest