Page 1 of 1

Custom USB 3.0 Cable with oCam-5MP?

Unread postPosted: Fri Oct 05, 2018 1:32 pm
by dlmutiny
I'm using an oCam-5MP with a C2. For my project, I'm trying to slim everything down as much as I can. Is it possible to make my own USB 3.0 Standard-A to Micro-B cable?

Is it as simple as matching the Pinouts between the two connectors? e.g. [ (Micro-B) pin 6 USB3 SSTX- to (Standard-A) pin 5 StdA_SSRX- ] so on through the rest of the pins.

USB 3.0 Micro-B pinout:
http://pinoutguide.com/PortableDevices/ ... nout.shtml
USB 3.0 Standard-A Pinout:
http://pinoutguide.com/Slots/usb_3_0_co ... nout.shtml

If that's the case, I'm not entirely clear on what to do with the OTG ID pin on the Micro-B connector.

Also, the Standard-A GND_DRAIN. I'm guessing that pin is wired to pin 8 GND on the Micro-B?