I have a couple of Odroid c1+'s no lobger used for media, that I would like to setup as temperature and humidity sensors in my crawl space under house. Then connect to Wifi network.
I have little to no experience with any programming. Open to learn, but would prefer something somewhat user-friendly or a Gui type approach if possible. Thanks in advance!
Need help with using c1+ as a temp/humidity sensor in crawl space
-
- Posts: 9257
- Joined: Wed Jul 15, 2015 5:00 pm
- languages_spoken: english
- ODROIDs: XU4, C1+, C2, C4, N1, N2, H2, Go, Go Advance
- Location: Bucharest, Romania
- Has thanked: 599 times
- Been thanked: 626 times
- Contact:
Re: Need help with using c1+ as a temp/humidity sensor in crawl space
Depending on your sensors, your best bet is to run HomeAssistant as a gui, and set up the sensors inside. There is no dedicated HA image for C1, but with a bit of work (disable apparmor), install docker, you can install it on c1.
This should get you started:
https://www.google.com/url?sa=t&source= ... 0LWIYh_PW-
This should get you started:
https://www.google.com/url?sa=t&source= ... 0LWIYh_PW-
Who is online
Users browsing this forum: No registered users and 1 guest